Liar 2

[Apeman!]

Name – Liar

Shape – A bit like a non-invertible Wheely Big Cheese, it has a fairly wide wheel-to-wheel base at the back, while the front is a much smaller (and pretty long) wedge, the front of the wedge has to “side wedges” as can be seen on the pic

Weight – 100 Kilogram

Speed – 29 km/h (18mph)

Dimensions – 120x60x30 cm

Ground Clearance – 0 mm at the front and underneath “side-wedges”, 7 mm anywhere else

Power – 2 S28-400 Magmotors at 24 volt

Movement – 2 inner wheels, 15 cm in diameter

Turning Circle - Zero

Weaponry – The wedge contains a 1000 psi titanium rear-hinged flipper (basically the red parts of the picture), powered by two pneumatic rams. It should be able to give a 100 kg robot a height of some meters. As can be seen in the picture, the flipper has two “side-wedges”. I have added them since I saw that flippers tend to be quite weak when attacked at the back. When Liar is attacked at the back, he simply does the same as Stinger does when he goes into flail mode. By doing so, the side wedge will ram into the opponent and shove underneath it. That way I can use my flipper and get it on his back. Although this flip will not be as powerful as a frontal flip, it will be a flip nonetheless, and it will help me get rid of any threats that approach me from the back.

Armour – 8 mm titanium all around

Srimech – That flipper

Strenghts – Powerful and maneuverable flipper
Weakness – Won’t be pushing much, won’t be damaging much either

[Apeman!]

Name – Liar 2

Shape – A lot like Wheely Big Cheese, only wider, with a more rounded back, and the wedge has sharp “whiskers”.

Weight – 100 Kilogram

Speed – 22 mph

Dimensions – 90x80x25 cm

Ground Clearance – Ranging from 0 mm under the front to 10 mm at the back

Power – 2 LEM130’s at 48 V

Movement – 2 large axlebot wheels with a part of the drive motors inside them, and strips of rubber over them for more traction.

Turning Circle - Zero

Weaponry – The wedge contains a 1000 psi rear-hinged flipper (basically the red parts of the picture) powered by 2x 2,5 kg nitrogen-filled canisters and a single ram with a 70 mm bore size and a 60 mm rod diameter. The tip can lift about a ton, and can easily flip a heavyweight out of the ring. I should have roughly 20-25 flips, and can flip both upside-up and upside-down.

Liar now has 2 30 cm long Hardox spikes at the sides of its wedge, practically turning it into a twackbot. My LEMs should give me a good acceleration and my 22 mph top speed means the spikes will swing around at 54 mph. I will run some calculations as to what this’ll mean for the energy-output, but at this point I can say this will be between 14,4 and 28,8 kJ

Armour – 6 mm Hardox for the wheels, 5 mm for the main body. The flipper ranges from 4 mm Hardox at the back to 7 mm at the front, serving 2 purposes. Centering the weight there will keep my flipper lower to the ground and will also add more weight behind a hit from the spike.

Srimech – Invertible

Strenghts – Powerful and maneuverable flipper
Weakness – Exposed wheels I think, though they’re damn sturdy