DreamCatcher

[Team BriteSpark]

Robot Name: DreamCatcher
Dimensions (LxWxH): 100cm x 100cm x 20cm
Shape: Very low dome.
Colour: Black with a purple pentagram painted on the top of the robot.
Weight: 100kg.
Drive: 2 x LEM130s running at 24v, powered by some 24v NiCad batteries.
Top Speed: ~18mph.
Wheels: 2 x 15cm diameter wheels made from Aluminium alloy, coated in Vulcalon for extra grip.
Armour: The entire dome is made from 4mm Hardox, with the blade made from 1cm Hardox. The baseplate is 5mm Polycarb.
Weapon: The robot is the weapon, in the form of a full body spinner. The shell is powered by a 3120XP Husqvarna chainsaw motor geared down 10:1. The shell can spin at a maximum speed of 2400RPM. On the shell is a large piece of 1cm thick Hardox, which goes from one side of the robot, along the top of the shell and down the other side of the robot, effectively making two blades from a single piece of Hardox. This piece is secured tightly onto the shell and will spin with the shell. The blade is 15cm wide and 1cm thick, and according to MatWeb weighs just under 12kg. This, when added to the weight of the shell, brings the total spinning mass to 42kg (again, according to MatWeb).
Turning Circle: 0m.
Ground Clearance: 4mm all around.
Srimech: None.

[Team BriteSpark]

Robot Name: Propane Nightmare
Dimensions (LxWxH): 80 x 80 x 30
Shape: Very similar to Y-Pout and Why Not - a triangle with each corner cut off.
Colour: Red and orange, with black flames on the top and bottom.
Weight: 100kg.
Drive: 3 x 3120XP Husqvarna chainsaw motors geared down 10: 1.
Top Speed: About 10mph to be on the safe side… ;D
Wheels: 3 x 30cm diameter, 15cm thick Aluminium alloy hubs with thick rubber treads.
Armour: Baseplate and top panels are 4mm Hardox, the rest of the body is made from a single piece of 4mm Hardox.
Weapon: The robot is the weapon, in the form of a translational spinner, similar to machines such as Y-Pout and Why Not (Team Whyachi’s MW and HW machines. The 3 x 3120XP Husqvarna chainsaw motors spin the whole 100kg weight of the machine around at speeds of roughly 2400RPM. There are 6 claws mounted on the outer edge of the body made from 5mm Hardox.
Turning Circle: 0m.
Ground Clearance: 6mm all around.
Srimech: Invertible.